烘缸滾刮干燥機 Continuously scraping drier with a drying cylinder

聯系人: 銷售部
電話: 028-85408899 15882331886
郵箱: Webmaster@cdgzkj.com
發布人: 川大干燥
留言咨詢 更多信息
分享:
關鍵詞: 烘缸滾刮干燥機   滾刮干燥機        

產品介紹

一、工作原理及應用范圍介紹 Introduction of Working Principle and Scope of Application


無縫承壓型鋼管經加工組合成單個或多個烘缸,滾筒烘缸在傳動系統帶動下作回轉運動,熱源通入烘缸內壁,筒體外壁部分浸入需干燥的料漿中,使一層物料均布于烘缸外表而被加熱,水被氣化帶走。滾筒轉動一周而物料就完成了干燥過程且結于烘缸表面,然后被刮 刀卸下從而完成干燥卸料的過程。

本機廣泛應用于高粘度、高濃度漿料的烘干,如:酵母泥、聚合氯化鋁(凈水劑)、糊精、尾渣、魚蝦飼料等。

    Seamless pressurized steel pipes are processed into single drying cylinder or multiple drying cylinders, and the drum drying cylinder is driven by the drive system to conduct a rotary motion, heat source enters into the inner wall of drying cylinder, and outer wall of drum is immersed into the slurry that has been dried, to make a layer of materials be evenly distributed on the outer surface of drying cylinder and heated, thus the moisture is taken away by vaporization. After the rotary drum rotates one cycle, the materials complete its drying process and solidify on the surface of drying cylinder, and then the materials are removed by the scraper to complete the process of drying and discharging.

    The drying machine is widely used for drying of slurry with high viscosity and concentration, such as yeast paste, aluminium polychlorid (purifier), dextrin, tailings and fish and shrimp feed.


二、特點Characteristics


1.  連續操作、質量穩定、節省勞動力,能夠得到均勻的產品。

2.  干燥時間短,一般約為7-30s,干燥產品沒有受高溫的危險,適合于熱敏性物料的干燥。

3.  適應料漿黏度范圍廣。

4.   熱效率高,可達70-80%。

5.  因干燥器內不會殘留產品,少量物料也可干燥。

6.  操作參數調整范圍廣,并易于調整。

7.  機內易于清理,改變用途容易。

8.  尾氣不帶走物料,不需除塵設備。

9.  設備操作彈性較大,易于控制調節。

10.  該機可用于環保行業的廢液處理。

11.   干燥速率大,筒壁上濕料膜的傳熱傳質過程由里向外,方向一致,溫度梯度較大,使料膜表面保持較高的蒸發強度。

1. Continuous operation, stable quality, labor-saving and able to obtain uniform products.

2. It has a short drying time, generally about 7-30s. It will not make the products to be dried suffer the risk of high temperature and it is suitable for drying of heat sensitive materials.

3. Wide adaption range for slurry viscosity.

4.  High thermal efficiency of 70-80.

5. Without residuary product in the drier, a small amount of materials can also be dried.

6. Operation parameters have a wide adjustment range and are easy for adjustment.

7. It is easy to clean the machine as well as change the use.

8. End gas doesn’t carry off materials and dust remover is not required.

9. With large equipment operating flexibility, it is easy for control and adjustment.

10.The machine can be used for liquid waste disposal in the environmental industry.

11.It has high drying speed, the heat and mass transfer process of wet materials membrane on the cylinder wall is from inside to outside in the same direction and with relatively large temperature gradient, to make the surface of materials cylinder wall keep a relatively high evaporation intensity.


三、技術參數(下表中數值僅供選型時參考)

Technical parameters (the values in the table below are for reference in type selection only)

1.jpg


、結構簡圖Dimension sketch

1.jpg1.jpg


川大干燥為您提供制藥、食品、化工、農林、飼料裝備,歡迎來電咨詢!

CopyRight ? 版權所有: 四川川大干燥科技工程有限責任公司 技術支持:縱橫天下 網站地圖 XML 備案號:蜀ICP備17001860號-1

本站關鍵字: 干燥設備 混合設備 粉碎設備 篩分設備 制藥設備 食品設備 飼料設備


掃一掃訪問移動端
免费AV片在线观看